Skip to content
SEINA-3D
initial water levelmelt inletswollen pool top

Simulation time

t = –

loading…

Loading case…

§ 02Results

FARO L-28: melt jet premixing

Melt mass
175 kg
Melt temperature
3053 K
Jet diameter
44 mm
Water depth
1.44 m
Pressure
0.51 MPa

A 44 mm jet of UO₂–ZrO₂ melt at 3053 K pours into 1.44 m of saturated water at 0.51 MPa. Between 2.9 s and 8.0 s the jet keeps breaking up, the fragments quench, and a debris bed builds up on the floor.

Table 1 · Conditions

Melt
175 kg UO₂–ZrO₂ (80/20 wt %), 3053 K
Jet
44 mm diameter, released at 2.27 m for 5.2 s
Water
1.44 m deep, 424 K (saturated)
Pressure
0.51 MPa
Vessel
0.71 m × 0.71 m square column
Grid
8 × 8 × 64 cells over 8.44 m; the lowest 3.43 m are shown
Shown
74 saved states, 2.87–8.00 s

Reading the view

  1. Dots follow the melt mass: one dot stands for about 2.9 g of melt. Sub-millimetre fragments hold only grams in total, so few of them are drawn.
  2. Saved states are 0.025–0.35 s apart. Between them each dot moves along its saved velocity. The solver reuses parcel IDs, so the display cannot follow one parcel from state to state; it hands over from one state to the next instead.
  3. Boiling makes the pool swell: the water–steam mixture rises well above the initial 1.44 m level. The cyan line marks where the horizontally averaged liquid fraction falls to 30 %.
  4. While the jet is pouring, it pushes the water aside and the steam it raises escapes upward along the jet at 7–27 m/s (cell averages), blowing fragments and droplets out of the pool like a fountain. Up to about 9 % of the melt mass is above the inlet height at times. No measurement is available to check this, and the coarse 9 cm cells, wider than the 44 mm jet, may overstate it.
  5. Water and steam are computed on the grid shown by the slice lines; the volume view blends between cell centres.

Drag to rotate · scroll or pinch to zoom · space to play or pause